STARGEAR Universal Roof/Wall Mount

Description

Designed to allow installation of all Starlink dishes – Mini, Gen2, Gen3, HP, and Performance to a roof or wall structure with appropriate 43mm/1.5” pipe mount (purchase separately to suit specific dish).

• Can be fixed to sheet metal clad roofing adequate support structure (purlins or girts) and walls/facias with solid construction (brick/blockwork).

• Will accommodate Outdoor Wireless Access Points (AP’s) and/or Wireless Bridge (B2B / Point-to-point) Connections and/or IP Security Cameras mounted underneath Starlink dish.

• Designed to comply with Australian Standards AS1170.2-2011 & AS4055-2012. Suitable to be mounted in Cyclonic Regions (wind speeds < 238km/hr) with supplied cyclone washers.

• Adjustable staybar lengths, clevis orientation and mounting holes allow for wide variety of mounting orientations – either up slope or down slope – from flat to vertical surfaces.

• Backstay mounting holes allow for mounting adjacent to roof edge whilst maintaining staybar angles from 60 min to 120 max. degrees ensuring maximum stability and security.

• All galvanized steel construction ensures maximum corrosion resistance for coastal installations whilst powder-coated grey finish improves aesthetics for modern appeal.

• Supplied with all galvanized hardware required for installation including dek-tite style gasket for cable/conduit penetration. Roofing silicone is recommended to be applied to all penetrations.

• Stargear recommends installation by government endorsed commercial antenna installers utilizing anti-fall equipment and an earth-leakage protection safety device.